Q-Series Cutters (Category Directory)

Q-Series Basics Q-Series VideosContour Cutting Q/ACutter Protection StripPinch Roller Placement on Graphtec and Q-Series CuttersLoading and Tracking on Graphtec and Q-Series CuttersOrigin Point on Graphtec and Q-Series CuttersProper Blade Depth  ...

Contour Cutting Q/A

What is Contour Cutting? Imagine printing a picture or drawing on a piece of paper and then cutting it out using a pair of scissors. A rushed job will probably yield sloppy cuts with an inconsistent border. Now, instead of paper and scissors, visualize the same image...

Resetting the Q-Series Cutter (24/30/42/54/64)

Follow these steps to reset your Q-Series cutter to Factory Defaults. Press and hold the UP arrow while powering on the cutter. Release the arrow after a few seconds or when the cutter displays : Press 1 for Default Settings Press 1 for Set Default Press 1 to Continue...

Correcting Contour Cut Problems

NOTE: This article assumes the reader has already activated the ARMS on his/her vinyl cutter and is experiencing misaligned contour cuts. Several factors help determine whether a contour cut will align properly with the object to which it is applied. Let’s...

Output Size Compensation

If the contour cut is off from the printed image, you should first perform the Sensor Position Adjustment on the cutter. If the cut continues to be inaccurate you may need to use the Output Size Compensation. Output Size Compensation allows the Production Manager to...